Valuebond Filter Cartridge

ValueBond Depth Filter Cartridge

A Parker Filtration Product – Asia Pacific

Product Lines

The ValueBond Nominal cartridge is one of the most economical high purity filters available in Parker. Constructed with a graded density matrix design using fine Polypropylene fibers, it provides low initial pressure drop for enhanced flow and the two-layers structure gives superior service life.

Features & Benefits

Two-layers structure cartridge, enhanced dirt holding capacity.
Polyproylene construct provides broad chemical compatibility for a variety of applications.
Thermally bonded without the use of any binders and adhesives.
Materials of construction listed in FDA 21 CFR.
Meets the latest EC Directives for Food Contact.

Operation Conditions

Maximum operating forward pressure:
- 80°C: 1.15 bar
- 60°C: 2.05 bar
- 20°C: 4.10 bar
*Recommended change out differential pressure: 2.4 bar
Maximum operating temperature: 80°C

* subject to operating temperature.

Applications of Product

Photographic Chemicals
DI Water
Plating Solutions
R.O. Pre-filtration
Membrane Pre-filtration
Oil field Fluids
Bleach
Potable Water
Chemical Processing Fluids

Product Specifications

Micron ratings: Available in nominal ratings of 0.5, 1, 3, 5, 10, 25, 50, 75 and100 micron
Material of construction: 100% melt-blown PP
Nominal Length: 10”, 20”, 30”, 40”, 50”, 60”
(254mm, 508mm, 762mm, 1016mm, 1270mm, 1524mm)
Inner / Outer Diameter: 28mm / 63mm

The Efficiency of ValueBond Filter Cartridge

Initial Pressure Drop
Rating (μm)	Aqueous Service PSI/GPM per 10” Cartridge
0.5	0.14
1	0.11
3	0.10
5	0.08
10	0.05
25	0.04
50	0.03
75	0.02
100	0.02

Dirt Holding Capacity
Rating (μm)	Capacity (g/ 10”)
0.5	25
1	40
3	50
5	63
10	105
25	120
50	150
75	175
100	200

Flow Rate and Pressure Drop Formulas
Flow Rate (gpm) = Clean ΔP x Length Factor / Viscosity x Flow Factor
Clean ΔP = Flow Rate x Viscosity x Flow Factor / Length Factor
Notes:

Clean ΔP ispsi differential at start.
Viscosity is centistrokes. Use Conversion. Tables for other units.
Flow Factor is ΔP/GPM at 1cks for 10” (or single).
Length Factors convert flow or ΔP from 10” (single length) to required cartridge length.